Powertrain, generic · Fuel and air metering, auxiliary emission controls

P004E Turbocharger/Supercharger Boost Control A Circuit Intermittent/Erratic

Check engine lightOn
EmissionsRelevant
Drive cycleRequired
Limp modePossible

"Boost control A" is the electrically driven actuator the engine control module uses to set boost pressure: depending on the engine a pulse-width modulated solenoid or vacuum converter at the wastegate, the control valve of variable turbine vanes, or an electric actuator with position feedback. The letters A and B denote two separate actuators, for example on the low- and high-pressure turbocharger of a two-stage system, not the cylinder banks. This code is set when the circuit signal drops out briefly or jumps, as with a loose contact. Boost then fluctuates and reduced power may occur only now and then. Without control the actuator usually falls back to its rest position, which on most engines means low boost; depending on the design too much boost is also possible.

Likely causes

Loose contact at the actuator connector
Wire broken internally by engine movement
Corroded terminals
Actuator itself faulty

Symptoms

  • Check engine light on, sometimes only intermittently
  • Loss of power or reduced power mode
  • Sudden, jerky loss of power
  • Overboost possible in rare cases

Repair estimate

DifficultyMediumDIY possible
Parts and labour€50–900
Time0.5–2.5 h

Typical range across vehicles; the real cost depends on what the testing finds.

Parts involved

boost control actuator aboost control actuator wiringengine control module

Related codes

P0045P0046P0047P0048P004F

References: law.cornell.edu, en.wikipedia.org, en.wikipedia.org.