Powertrain, generic · Computer and auxiliary outputs

P063A Generator Voltage Sense Circuit A

Check engine lightUsually off
EmissionsNot relevant
Drive cycleNot required
Limp modeNo

Some charging systems measure the actual battery or alternator voltage through a separate sense line (regulator terminal S or an input of the module) to compensate voltage drops in the charging cable; without it the system reports a charging fault. No manufacturer document available to us uses P063A–P063D, so these descriptions follow the circuit principle and CARB, under which a charging-system input needs the check engine light only if it affects emissions or other diagnostics. P063A is the general or open-circuit code of sense circuit A; range, low and high are P063B–P063D. It differs from the F feedback (P0622/P0625/P0626) and the L line (P0621); the module's own supply voltage is monitored as P0560–P0563.

Likely causes

Sense wire, fuse or connector between battery and alternator or module open or corroded
Alternator or regulator faulty
Contact resistance at battery terminals or grounds
Battery faulty

Symptoms

  • Battery warning lamp on
  • Charging voltage too high or too low (flat or overcharged battery)
  • Flickering lights
  • Further voltage codes (P0562/P0563)

Repair estimate

DifficultyMediumWorkshop job
Parts and labour€20–600
Time0.5–2.5 h

Typical range across vehicles; the real cost depends on what the testing finds.

Parts involved

generator voltage sense circuitalternatorbattery

Related codes

P063BP063CP063DP0562P0563

References: law.cornell.edu, pmmonline.co.uk, hella.com.