Powertrain, generic · Transmission

P0825 Gear Lever Push-Pull Switch (Shift Anticipate)

Check engine lightUsually off
EmissionsNot relevant
Drive cycleNot required
Limp modeNo

P0825 concerns a switch on the selector that reports pushing or pulling the lever – sequential + and – shifting – or the start of a shift movement, hence 'shift anticipate'. Its purpose: the control unit of an automated manual gearbox can prepare clutch and engine torque before the actual gear change is detected; a LuK patent describes such shift-intent detection, which reports intent when the lever signal exceeds a filtered, load-dependent reference and cancels on a reversal. A fault is typically a switch reporting 'pressed' without lever movement or never, implausible against the X/Y sensors. No manufacturer document with P0825 is available to us. Shift-intent detection is then off, gear changes are slower or sequential shifting is disabled.

Likely causes

Switch in the selector faulty or sticking
Wire or connector to the selector assembly
Liquid or dirt in the shift gate
Control module

Symptoms

  • Delayed or jerky gear changes (automated manual)
  • Sequential tapping not working
  • Transmission warning in the cluster

Repair estimate

DifficultyMediumWorkshop job
Parts and labour€80–600
Time0.5–2 h

Typical range across vehicles; the real cost depends on what the testing finds.

Parts involved

gear lever switchgear selectorswitch wiringtransmission control module

Related codes

P0826P0815P0816P0820

References: patents.google.com, saabwisonline.com, law.cornell.edu.