Body, generic

B010E Camera Washer Actuator E

Check engine lightUsually off
EmissionsNot relevant
Drive cycleNot required
Limp modeNo

B010E names actuator E, which may be a dedicated pump rather than a valve. Audi's TSB 2073568/1 (2024) for e-tron, e-tron S and Q8/SQ8 e-tron models reports rear camera washer pressure too low to clean the lens: the mono pump could not build enough pressure, and production moved to a dual pump (1K6 955 651) whose spare outlet is plugged. Before swapping it, technicians rule out low fluid, a clogged pump filter, low supply voltage and kinked lines. AUMOVIO lists its washer pumps with one or two outlets for 2.0 to 4.0 bar. A pump drawing no current or too much is the kind of fault a module can flag; whether any maker calls that pump E is not published, and no manufacturer documents B010E.

Likely causes

Camera washer pump motor E worn, seized or open
Low supply voltage or poor ground at the pump
Clogged inlet filter making the pump labour and draw high current

Symptoms

  • Camera nozzle only dribbles; the spray does not reach across the lens
  • Pump hum without spray, or no pump sound at all when the wash is requested

Repair estimate

DifficultyMediumDIY possible
Parts and labour€40–250
Time0.5–1.5 h

Typical range across vehicles; the real cost depends on what the testing finds.

Parts involved

camera washer actuator ewasher pumpactuator wiring

Related codes

B010DB010FB011C

References: static.nhtsa.gov, aumovio.com.